--- dmesg-2.6.21-rc5-nohpet-error-notime 2007-03-26 16:42:00.000000000 +0800 +++ dmesg-2.6.21-rc5-nohpet-success-notime 2007-03-26 16:42:09.000000000 +0800 @@ -100,7 +100,7 @@ Enabling unmasked SIMD FPU exception support... done. Initializing CPU#0 PID hash table entries: 4096 (order: 12, 16384 bytes) -Detected 1952.283 MHz processor. +Detected 1830.920 MHz processor. Console: colour VGA+ 80x25 Dentry cache hash table entries: 131072 (order: 7, 524288 bytes) Inode-cache hash table entries: 65536 (order: 6, 262144 bytes) @@ -114,7 +114,7 @@ .data : 0xc03460bb - 0xc041782c ( 837 kB) .text : 0xc0100000 - 0xc03460bb (2328 kB) Checking if this processor honours the WP bit even in supervisor mode... Ok. -Calibrating delay using timer specific routine.. 5586.61 BogoMIPS (lpj=2793309) +Calibrating delay using timer specific routine.. 5861.22 BogoMIPS (lpj=2930614) Mount-cache hash table entries: 512 CPU: After generic identify, caps: bfe9fbff 00100000 00000000 00000000 0000c1a9 00000000 00000000 monitor/mwait feature present. @@ -143,7 +143,7 @@ SMP alternatives: switching to SMP code Booting processor 1/1 eip 3000 Initializing CPU#1 -Calibrating delay using timer specific routine.. 3661.27 BogoMIPS (lpj=1830637) +Calibrating delay using timer specific routine.. 3661.26 BogoMIPS (lpj=1830631) CPU: After generic identify, caps: bfe9fbff 00100000 00000000 00000000 0000c1a9 00000000 00000000 monitor/mwait feature present. CPU: L1 I cache: 32K, L1 D cache: 32K @@ -154,12 +154,12 @@ Intel machine check architecture supported. Intel machine check reporting enabled on CPU#1. CPU1: Intel Genuine Intel(R) CPU T2400 @ 1.83GHz stepping 08 -Total of 2 processors activated (9247.89 BogoMIPS). +Total of 2 processors activated (9522.49 BogoMIPS). ENABLING IO-APIC IRQs ..TIMER: vector=0x31 apic1=0 pin1=2 apic2=-1 pin2=-1 checking TSC synchronization [CPU#0 -> CPU#1]: passed. Brought up 2 CPUs -migration_cost=47 +migration_cost=33 PM: Adding info for No Bus:platform NET: Registered protocol family 16 PM: Adding info for No Bus:vtcon0 @@ -333,8 +333,8 @@ PCI: Using ACPI for IRQ routing PCI: If a device doesn't work, try "pci=routeirq". If it helps, post a report pnp: 00:01: iomem range 0xe0000000-0xefffffff could not be reserved -pnp: 00:01: iomem range 0xfed14000-0xfed17fff could not be reserved Time: tsc clocksource has been installed. +pnp: 00:01: iomem range 0xfed14000-0xfed17fff could not be reserved pnp: 00:01: iomem range 0xfed18000-0xfed18fff could not be reserved pnp: 00:01: iomem range 0xfed19000-0xfed19fff could not be reserved pnp: 00:06: iomem range 0xfed00000-0xfed003ff has been reserved @@ -385,7 +385,7 @@ Machine check exception polling timer started. PM: Adding info for platform:pcspkr audit: initializing netlink socket (disabled) -audit(1174898085.428:1): initialized +audit(1174898442.397:1): initialized highmem bounce pool size: 64 pages Total HugeTLB memory allocated, 0 io scheduler noop registered @@ -594,8 +594,8 @@ PM: Adding info for No Bus:usbdev4.1_ep00 usb usb4: configuration #1 chosen from 1 choice PM: Adding info for usb:4-0:1.0 -hub 4-0:1.0: USB hub found usb 1-1: new low speed USB device using uhci_hcd and address 2 +hub 4-0:1.0: USB hub found hub 4-0:1.0: 2 ports detected PM: Adding info for No Bus:usbdev4.1_ep81 PM: Adding info for No Bus:usbdev4.1 @@ -706,16 +706,24 @@ PM: Adding info for usb:5-0:1.0 hub 5-0:1.0: USB hub found hub 5-0:1.0: 8 ports detected -usb 2-2: USB disconnect, address 2 -PM: Removing info for usb:2-2:1.0 -PM: Removing info for No Bus:usbdev2.2 -PM: Removing info for No Bus:usbdev2.2_ep00 -PM: Removing info for usb:2-2 +usb 4-1: USB disconnect, address 2 +PM: Removing info for No Bus:usbdev4.2_ep81 +PM: Removing info for usb:4-1:1.0 +PM: Removing info for No Bus:usbdev4.2_ep82 +PM: Removing info for usb:4-1:1.1 +PM: Removing info for No Bus:usbdev4.2 +PM: Removing info for No Bus:usbdev4.2_ep00 +PM: Removing info for usb:4-1 PM: Adding info for No Bus:usbdev5.1_ep81 PM: Adding info for No Bus:usbdev5.1 tun: Universal TUN/TAP device driver, 1.6 tun: (C) 1999-2004 Max Krasnyansky PM: Adding info for No Bus:tun +usb 2-2: USB disconnect, address 2 +PM: Removing info for usb:2-2:1.0 +PM: Removing info for No Bus:usbdev2.2 +PM: Removing info for No Bus:usbdev2.2_ep00 +PM: Removing info for usb:2-2 (on-line) (battery present) input: Power Button (FF) as /class/input/input5 @@ -753,13 +761,13 @@ PM: Removing info for usb:3-2 usbcore: registered new interface driver appletouch usb 1-2: reset full speed USB device using uhci_hcd and address 3 -hfs: write access to a jounaled filesystem is not supported, use the force option at your own risk, mounting read-only. PM: Removing info for No Bus:usbdev1.3_ep83 PM: Adding info for No Bus:usbdev1.3_ep83 PM: Removing info for No Bus:usbdev1.3_ep81 PM: Adding info for No Bus:usbdev1.3_ep81 PM: Removing info for No Bus:usbdev1.3_ep84 PM: Adding info for No Bus:usbdev1.3_ep84 +hfs: write access to a jounaled filesystem is not supported, use the force option at your own risk, mounting read-only. usb 3-2: new full speed USB device using uhci_hcd and address 3 PM: Adding info for No Bus:rtc Real Time Clock Driver v1.12ac @@ -784,14 +792,6 @@ on usb-0000:00:1d.0-1 PM: Adding info for No Bus:usbdev1.4_ep81 PM: Adding info for No Bus:usbdev1.4 -usb 4-1: USB disconnect, address 2 -PM: Removing info for No Bus:usbdev4.2_ep81 -PM: Removing info for usb:4-1:1.0 -PM: Removing info for No Bus:usbdev4.2_ep82 -PM: Removing info for usb:4-1:1.1 -PM: Removing info for No Bus:usbdev4.2 -PM: Removing info for No Bus:usbdev4.2_ep00 -PM: Removing info for usb:4-1 usb 4-1: new full speed USB device using uhci_hcd and address 3 PM: Adding info for usb:4-1 PM: Adding info for No Bus:usbdev4.3_ep00